I've got 2 wink hubs. One I purchased new and has my devices connected and working from the Wink App. I went to root the hub with the serial method, but I get no output via serial. I'm not sure if that's because my hub is fully updated, or a soldering issue, or if I shorted/blew something when I attached the serial. So I went and bought a 2nd hub (used) to experiment with. This one shows serial output when it boots, so I'm pretty sure I can root it without issue (I haven't yet). I was trying to add the 2nd hub to my Wink App, but I can't seem to get it to add. I can enter the WiFi info and it eventually turns blue, then it goes back to purple blinking. If I reboot it, it stays blue, but still doesn't show up in the app.
So right now I have one hub I can't seem to root, and another I can't seem to use in the Wink app. Any suggestions for either rooting the first hub or adding the 2nd hub to the wink app?
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest